MULTIQUIP J36R60 Specifikace stáhnout pdf (Strana 17)

JA-SERIES WALK-BEHIND TROWEL — PARTS & OPERATION MANUAL — REV. #6 (11/14/05) — PAGE 17

Figures 3 shows the location of the Basic controls or components,

for the JA-Series trowel. Listed below is a brief explanation of

each control or component

1. Quick Pitch™ Control Handle – To adjust the pitch of

the blades, grasp the handle then squeeze and either move

the handle forward or backward to achieve the desired

blade pitch.

2. Handlebar Adjuster – Change the angle/height of the

handle bars by loosening star wheel, adjust handlebars to

desired location, tighten starwheel firmly to hold handlebars

in that position.

3. Hand Grip/Handlebar – When operating the trowel, place

both hands on each grip to maneuver the trowel. Replace

hand grips when they become worn or damaged.

4. Throttle Control Grip – Controls the speed of the engine.

Rotate the hand grip away from the operator to increase

engine speed (high), toward the operator to decrease

engine speed (low).

5. Throttle – Controls engine speed when throttle control

grip is rotated.

6. Hand Grip/Handlebar – When operating the trowel, place

both hands on each grip to maneuver the trowel. Replace

hand grips when they become worn or damaged.

7. Centrifugal Kill Switch – In the event the operator loses

control of the trowel, this switch will shut-down the engine.

8. Auxiliary Lifting Tube - Use this tube to lift the trowel onto

a slab. Tube is to be inserted into socket located in front of

the gearbox.

9. V-Belt Cover – Remove this cover to gain access to the V-

belt. NEVER operate the trowel with this cover removed.

10. Trowel Lifting Point – Insert the auxiliary lifting tube here.

See Figure 21.

11. Pitch Control (standard models) - Turn this "Star Wheel"

clockwise for increase blade pitch, and counter-clockwise

for decrease blade pitch.

12. Clutch Lever - Clutch engagement lever. When this lever

is engaged, the blades will begin to rotate. May be used

with either Quick Pitch™ or Standard handle.

13. Main Tube - When disassembling components inside the

tube exercise extreme CAUTION! Tube is spring-loaded,

severe injury could result if not disassembled correctly.

14. Guard Ring- NEVER put hands or feet inside guard ring.

15. Engine – This trowel uses Honda, Robin and Briggs and

Stratton type gasoline engines.

16. Trowel Arm – NEVER operate the trowel with a bent,

broken or out of adjustment trowel arm. If the blades show

uneven wear patterns or some blades wear out faster than

others, the trowel arm may need to be adjusted. Use the

trowel arm adjustment tool P/N 1817 to adjust the trowel

arms.

17. Blades – This trowel is equipped with combination blades.

These blades are versatile and should take care of most

troweling needs. In addition float discs can be attached to

the trowel arms that will allow the trowel to float on "wet"

concrete.

JA-SERIES TROWEL— CONTROLS AND COMPONENTS

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 119 120

Komentáře k této Příručce

Žádné komentáře

MULTIQUIP J36R60 Specifikace Strana 17

Komentáře k této Příručce

Související produkty a manuály pro Hračky a příslušenství MULTIQUIP J36R60