MULTIQUIP J36R60 Specifikace stáhnout pdf (Strana 19)

JA-SERIES WALK-BEHIND TROWEL — PARTS & OPERATION MANUAL — REV. #6 (11/14/05) — PAGE 19

JA-SERIES TROWEL — ASSEMBLY AND INSTALLATION

Assembly and Installation

Before the trowel can be put into operation there are some

components that must be installed before the trowel can be used.

This section provided general instructions on how to install those

components. Instruction sheet P/N 20485 provides further details

for the handle assembly.

Handle Tube Installation (All Models)

1. Install the

handle tube

to the gearbox as shown in (Figure 5).

The mounting hardware should be contained in the shipping

container.

Figure 5. Handle Tube Installation

CAUTIONCAUTION

CAUTION

The Quick-Pitch™ handle is spring loaded,

personal injury or damage could result from

improper handling or installation. Be careful

when installing this component.

NOTE

Considerable force may be required when

moving the Quick-Pitch™ T-handle

forward or backward.

2. On Quick-Pitch™ models, pivot the

T-handle

back

(full pitch) (Figure 6). This will relax the spring inside the

handle tube. On either model, spread the handle bar ends

just enough to engage the teeth on the handle tube. Attach

the hand wheel assembly, position handlebar to desired

location, and tighten hand wheel firmly.

Figure 6. Handlebar Installation

2. Feed the throttle cable through the cable housing. Make sure

the throttle indicator is on 1".

3. Connect the throttle cable to the engine. (Figure 8),

Honda

and (Figure 9),

Robin

. There should be a piece of wire

installed on the trowel to show where to route the throttle

cable. When connecting the cable housing, make sure that

no more than

1/4" (6.4mm)

of the cable housing protrudes

past the housing clamp on the engine.

Figure 8. Throttle Cable Connection (HONDA)

CABLE HOUSING

ENGINE

THROTTLE

LEVER

SWIVEL STOP

SCREW

THROTTLE

CABLE END

CABLE

HOUSING

CLAMP

Figure 7. Throttle

Throttle Cable Installation (Honda and Robin Engines)

1. Set the

throttle

(Figure 7) to the idle position by rotating

the grip toward the operator and away from the engine.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 119 120

Komentáře k této Příručce

Žádné komentáře

MULTIQUIP J36R60 Specifikace Strana 19

Komentáře k této Příručce

Související produkty a manuály pro Hračky a příslušenství MULTIQUIP J36R60