MULTIQUIP J36R60 Specifikace stáhnout pdf (Strana 20)

PAGE 20 — JA-SERIES WALK-BEHIND TROWEL— PARTS & OPERATION MANUAL — REV. #6 (11/14/05)

JA-SERIES TROWEL — ASSEMBLY AND INSTALLATION

Handle Height Adjustment

If handle height adjustment is desired, a handle wedge kit can be

purchased for your trowel by ordering P/N 2576 from your Multiquip

dealer. These wedges are placed between the handle and the

gearbox to adjust the operating height of the handle. This kit

comes complete with wedges, new bolts and installation

instructions. This will move your operating handle position up or

down approximately 3” (76mm).

Safety Kill Wire

Locate the

RED

wire protruding from the handle tube (Figure11)

and connect it to the

RED

tail wire on the engine. Test the kill

switch to insure proper operation.

Figure 11. Engine Kill Wire Connection

Figure 12. "No Pitch" Position (Standard)

Figure 13. "No Pitch" Position (Quick-Pitch™)

1. Expose the pitch cable to maximum by adjusting the handle

pitch to the "no pitch" position. On the standard model turn

the pitch control counter-clockwise, (Figure 12). On the

Quick-Pitch™ model, pivot the pitch handle forward or no

pitch, (Figure 13).

Figure 9. Throttle Cable Connection (ROBIN)

7. These are general instructions. Installation of the throttle

cable may vary for different engine configurations. Please

look for more detailed instructions inside the box containing

the handle. These more detailed instructions should provide

adequate guidance for installing.

4. Tighten cable clamp screw and swivel stop screw.

5. After the cable has been installed on the engine, adjust

and tighten operator position of the handle to lock the

throttle cable at the proper length.

6. Adjust cable tension by rotating the barrel adjuster. (Figure

10)

Pitch Cable Installation

BARREL ADJUSTER

Figure 10. Barrel Adjuster

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 119 120

Žádné komentáře

MULTIQUIP J36R60 Specifikace Strana 20