MULTIQUIP FS2 Provozní pokyny stáhnout pdf (Strana 24)

PAGE 24 — MQ-WHITEMAN FS2 CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #2 (11/08/01)

3. Check V-belt tension (Figure 15) by using a tensionmeter

(6.0 - 9.0 lbs) against the inside belt at a mid point between

the two pulleys, or by deflecting the center belt at a mid point

3/8” (10mm) - 1/2” (13mm).

Figure 15. V-Belt Tension

DO NOT over or under tension the V-belts. Severe damage

can occur to the saw and engine crank shaft if the belts are

over tensioned. A decrease of power to the blade and poor

performance will result if the belts are under tensioned (loose

on pulleys).

5. If the V-belts becomes worn or loose, replace them by using

V-belt part number 15082.

FS2 CONCRETE SAW — INSPECTION -GUARDS, COVERS AND V-BELTS

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 57 58

Žádné komentáře

MULTIQUIP FS2 Provozní pokyny Strana 24