Multiquip DCA25USI2 Uživatelský manuál stáhnout pdf (Strana 22)



OUTPUT TERMINAL PANEL FAMILIARIZATION



Loads can be connected to the generator by the output

terminal lugs or the convenience receptacles (Figure 11).

Make sure to read the operation manual before attempting

to connect a load to the generator.

To protect the output terminals from overload, a 3-pole, 60

amp main circuit breaker is provided. Make sure to switch

 circuit breakers to the OFF position prior to starting

the engine.

Figure 11. Connecting Loads

Over Current Relay

An over current relay (Figure 12) is connected to the main

circuit breaker. In the event of an overload, both the circuit

breaker and the over current relay may trip. If the circuit

breaker can not be reset, the reset button on the over

current relay must be pressed. The over current relay is

located in the control box.

Figure 12. Over Current Relay

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 79 80

Žádné komentáře

Multiquip DCA25USI2 Uživatelský manuál Strana 22