Multiquip DCA150SSJU3 Uživatelský manuál Strana 53

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 102
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 52
DCA150SSJU3 50 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (02/01/10) — PAGE 53
STARTING (AUTO MODE)
DANGER
Before connecting this generator to any
building’s electrical system, a licensed
electrician must install an isolation
(transfer) switch. Serious damage to
the building’s electrical system may occur
without this transfer switch..
CAUTION
When connecting the generator to a isolation (transfer)
switch, ALWAYS have power applied to the generator's
internal battery charger. This will ensure that the engine
will not fail due to a dead battery.
NOTICE
When the generator is set in the AUTO mode, the
generator will automically start in the event of comercial
power falling below a prescribed level by means of a
contact closure that is generated automatically by a
transfer switch.
WARNING
When running the generator in the AUTO mode,
remember the generator can start up at any time without
warning. NEVER attempt to perform any maintenance
when the generator is in the auto mode.
CAUTION
The engine speed switch must be set to the High
position when running in the Auto-Start mode. Failing
to set the switch in the proper position can result in
damage to your generator when it turns on.
NOTICE
When the MPEC control switch is placed in the AUTO
position, the engine glow plugs will be warmed and the
engine will start automatically.
When starting generator in AUTO mode use the "Manual
Start-up" procedure except where noted (see below).
1. Perform steps 1 through 6 in the Before Starting
section as outlined in the Manual Starting Procedure.
2. Place the engine speed switch (Figure 55) in the
HIGH position.
Figure 55. Engine Speed Switch (High)
3. Place the MPEC control switch (Figure 56) in the
AUTO position.
Figure 56. MPEC Control Switch (AUTO)
4. Continue operating the generator as s outlined in the
Manual Start-up procedure (start at step 5).
GENERATOR START-UP PROCEDURE (AUTO)
Zobrazit stránku 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 101 102

Komentáře k této Příručce

Žádné komentáře